Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 226)

216 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
Define the following MINT Link Settings in respect to devices supported by the profile:
Select the Tunnel Controller Load Balancing (Level1) option to enable load balancing on the tunnel
controller.
Define the group name for clustered tunnel controllers in the Preferred Tunnel Controller Name
field.
Select OK to save the changes made to the Settings tab. Select Reset to revert to the last saved
configuration.
Select the IP tab to display the link IP network address information shared by the devices managed
by the access point’s MINT configuration. The IP tab displays the IP address, routing level, link cost,
hello packet interval and adjacency hold time settings used by managed devices to securely
communicate amongst one another within the IPSec network.
FIGURE 103 Advanced Profile Configuration - MINT Protocol screen - IP tab
Select Add to create a new Link IP configuration or Edit to modify an existing MINT configuration.
MLCP IP Select this option to enable MINT Link Creation Protocol (MLCP) by IP Address. MLCP by IP is
used to create one UDP/IP link from the device to a neighbor. The neighboring device does not
need to be a Virtual Controller, it can be an standalone access point.
MLCP VLAN Select this option to enable MLCP by VLAN. MLCP by VLAN is used to create one VLAN link from
the device to a neighbor. The neighboring device does not need to be a Virtual Controller, it can
be an standalone access point.
Tunnel MiNT across extended
VLAN Select this option to enable tunneling MiNT protocol packets across extended VLANs.