Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 347)

Brocade Mobility Access Point System Reference Guide 337
53-1003100-01
5
FIGURE 179 VPN Step-By-Step Wizard - Step 1
Define the following:
Click the Next button to go to Step 2.
Tunnel Name Provide a name for the tunnel in the Tunnel Name field.
Tunnel Type Select the tunnel type being created. Two types of tunnels can be created. Site to Site is used to create
a tunnel between two remote sites as indicated in the image. Remote Access is used to create a tunnel
between an user device and a network as indicated in the image.
Interface Select the interface to use. Interface can be a Virtual LAN (VLAN) or WWAN or PPPoE depending on the
interfaces available on the device.
Traffic Selector (ACL) This field creates the Access Control List (ACL) that is used to control who uses the network. Provide the
Source and Destination IP address ranges with their net mask. Click the Add Rule button to add the rule
into the ACL.