Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 34)

24 Brocade Mobility Access Point System Reference Guide
53-1003100-01
3
FIGURE 8 Initial Setup Wizard - WAN Configuration screen of the Typical Setup Wizard
Set the following WAN parameters:
• Use DHCP - Select the radio control to enable an automatic network address configuration
using external DHCP servers. An automatic IP address is configured to the access point’s
WAN port using DHCP servers located on the WAN side of the network.
• Static IP Address/Subnet - Enter an IP Address and a subnet for the access point's WAN
interface. If Use DHCP is selected, this field is not available. When selecting this option,
define Default Gateway information, as the field will become enabled on the bottom
portion of the screen. The provided IP address is assigned to the WAN interface of the
access point. The Default Gateway is a router that serves as a access to other networks.
• Select the port that is connected to the WAN – Select the port connected to the WAN.
• Enable NAT on the WAN Interface – Select the option to enable Network Address
Translation (NAT) on the selected GE interface.
1. Select Next. The Typical Setup Wizard displays the Wireless LAN Setup screen to set the access
point's wireless LAN configuration. For more information, see Wireless LAN Setup on page
3-25.