Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 348)

338 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
FIGURE 180 VPN Step-By-Step Wizard - Step 2
In Step 2 screen, configure the following parameters:
Click the Add Peer button to add the Tunnel peer information into the Peer(s) table. This table lists
all the peers configured for the VPN Tunnel.
Peer Select the type of peer for this device when forming a tunnel. Peer information can be either IP Address
or Host Name. Provide the IP address or the hostname of the peer device.
Authentication Configure how the devices authenticate with each other.
•
Certificate – The devices use certificates to validate credentials.
•
Pre-Shared Key – The devices use pre-shared key to authenticate.
Local Identity Configure the local identity for the VPN Tunnel.
•
IP Address – The local identity is an IP address.
•
FQDN – The local identity is a Fully Qualified Domain Name (FQDN).
•
Email – The local identity is an E-mail address.
Remote Identity Configure the remote identity for the VPN Tunnel.
•
IP Address – The remote identity is an IP address.
•
FQDN – The remote identity is a Fully Qualified Domain Name (FQDN).
•
Email – The remote identity is an E-mail address.
IKE Policy Configure the IKE policy to use when creating this VPN Tunnel. The following options are available:
•
Use Default – Click this option to use the default IKE profiles. Select one of ike1-default or
ike2-default.
•
Create new Policy – Click this option to create a new IKE policy.