Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 112)

102 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
FIGURE 27 Access Point Radio - Advanced Settings tab
22. Refer to the Aggregate MAC Protocol Data Unit (A-MPDU) field to define how MAC service
frames are aggregated by the access point radio.
23. Use the Aggregate MAC Service Data Unit (A-MSDU) drop-down menu to set the supported
A-MSDU mode.
Available modes include Receive Only and Transmit and Receive. Transmit and Receive is the
default value. Using Transmit and Receive, frames up to 4 KB can be sent and received. The buffer
limit is not configurable.
Set the following Aeroscout Properties for the selected access point radio:
A-MPDU Modes Use the drop-down menu to define the A-MPDU mode supported. Options include Transmit Only,
Receive Only, Transmit and Receive and None. The default value is Transmit and Receive. Using the
default value, long frames can be both sent and received (up to 64 KB). When enabled, define
either a transmit or receive limit (or both).
Minimum Gap Between
Frames Use the drop-down menu to define the minimum gap between A-MPDU frames (in microseconds).
The default value is 4 microseconds.
Received Frame Size Limit If a support mode is enable allowing A-MPDU frames to be received, define an advertised
maximum limit for received A-MPDU aggregated frames. Options include 8191, 16383, 32767 or
65535 bytes. The default value is 65535 bytes.
Transmit Frame Size Limit Use the spinner control to set limit on transmitted A-MPDU aggregated frames. The available range
is from 2000 - 65,535 bytes). The default value is 65535 bytes.
Forward Use the Forward option to forward Aeroscout packets to the server.
MAC to be forwarded Use the text area to provide a MAC address that identifies that the packet is received from
Aeroscout tags.