Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 219
Brocade Mobility Access Point System Reference Guide
209
53-1003100-01
5
Refer to the following for more information on the Path Method Root Path Metric screen. These
descriptions apply to both the 2.4 GHz and 5.0/4.9 GHz frequencies.
Select OK to save the changes. Select Reset to revert to the last saved configuration. Select Exit to
close this screen.
Vehicle Mounted Modem (VMM) Deployment Consideration
Before defining a VMM configuration (mounting an AP7161 mesh point on a moving vehicle), refer
to the following deployment guidelines to ensure the configuration is optimally effective:
•
Disable layer 2 stateful packet inspection from the firewall policy.
•
Set the RTS threshold value to 1 on all mesh devices. The default value is 2347. For more
information on defining radio settings, see
Access Point Radio Configuration
•
Use Opportunistic as the rate selection settings the default is Standard. For more information
on defining this settings, see
•
Disable Dynamic Chain Selection (radio setting). The default value is enabled. This setting is
disabled from the Command Line Interface (CLI) using the
dynamic-chain-selection
command, or, in the UI (refer
.
Channel Width
Configure the channel width that mesh point automatic channel scan should assign to the
selected radio. The available options are:
•
Automatic – Indicates the channel width is calculated automatically. This is the default value.
•
20 MHz – Indicates the width between two adjacent channels is 20 MHz.
•
40 MHz – Indicates the width between two adjacent channels is 40 MHz.
Priority Meshpoint
Configure the mesh point monitored for automatic channel scan. This is the mesh point given
priority over other available mesh points. When configured, a mesh is created with this mesh point.
When not configured, a mesh point is automatically selected.
Meshpoint Path Minimum
Configure the minimum path metric value for a mesh connection to be established. Set a value
between 100 - 20,000.
Meshpoint Path Metric
Threshold
Configure a minimum threshold value for triggering an automatic channel selection for mesh point
selection. Set a value in between 800 - 65535.
Meshpoint Tolerance
Period
Configure the time duration in seconds to wait before triggering a automatic channel selection for
the next hop.
Meshpoint Root Sample
Count
Configure the number of scans performed for data collection before a mesh point root is selected.
Set a value between 1 - 10 scans.
Meshpoint Root
Off-channel Duration
Configure the duration in the range of 20 - 250 milliseconds for the Off Channel Duration field
when scanning for mesh point root. This is the duration the scan dwells on each channel when
performing an off channel scan.
Meshpoint Root Channel
Switch Delta
Configure the delta value in dBm in the range 5 - 35 dBm which when crossed triggers a mesh
point root automatic channel selection.
Meshpoint Root
Off-channel Scan
Frequency
Configure the time duration in seconds between two consecutive Off Channel Scans for mesh
point root. Set a duration between 1 - 60 seconds.
Meshpoint Root Channel
Hold Time
Configure the minimum duration to stay on a selected channel before the channel conditions are
reassessed for a possible channel change for mesh point root. Set a value between 0 - 1440
minutes. Set this value to ‘Zero’ (0) to prevent a automatic channel selection from happening.