Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 315)

Brocade Mobility Access Point System Reference Guide 305
53-1003100-01
5
FIGURE 157 Device Overrides - Network - Network Routing screen
Select the IP Routing option to enable IP routing using static routes provided in the route table. This
option is enabled by default.
Select the Policy Based Routing policy to apply to this profile. Click the Create icon to create a policy
based route or click the Edit to edit an existing policy after selecting it in the drop-down list. For
more information on policy based routing, see Policy Based Routing (PBR) on page 7-491.
Select Add Row + as needed to include single rows with in the static IPv4 route table.
Add IP addresses and network masks in the Network column.
Provide the Gateway used to route traffic.
Refer to the Default Route Priority field and set the following parameters:
Static Default Route Priority Use the spinner control to set the priority value (1 - 8,000) for the default static route. The default
setting is 100.
DHCP Client Default Route
Priority Use the spinner control to set the priority value (1 - 8,000) for the default route learnt from the
DHCP client. The default setting is 1000.
Enable Routing Failure When selected, all default gateways are monitored for activity. The system will failover to a live
gateway if the current gateway becomes unusable. This feature is enabled by default.