Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 488)

478 Brocade Mobility Access Point System Reference Guide
53-1003100-01
6
7. Select OK to update the MeshConnex Configuration settings for this policy. Select Reset to
revert to the last saved configuration.
8. Select the Security tab.
FIGURE 40 MeshConnex - Security screen
9. Refer to the Select Authentication field to define an authentication method for the mesh policy.
Control VLAN Use the spinner control to specify a VLAN to carry mesh point control traffic. The valid range for
control VLAN is from 1 - 4094. The default value is VLAN 1.
Allowed VLAN Specify the VLANs allowed to pass traffic on the mesh point. Separate all VLANs with a comma. To
specify a range of allowed VLANs separate the starting VLAN and the ending VLAN with a hyphen.
Neighbor Inactivity
Timeout Specify a Neighbor Inactivity Timeout in seconds, minutes, hours or days, up to a maximum of 1
day. The Neighbor Inactivity Timeout is the allowed amount of time between frames received from a
neighbor before their client privileges are revoked. The default value is 2minutes.
Description Enter any descriptive text about the mesh point.
Security Mode Select a security authentication mode for the mesh-point. Select none to set no authentication for
the mesh point. Select psk to set a pre-shared key as the authentication for the mesh-point. If psk is
selected enter a pre-shared key in the Key Settings field.