Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual

Page 232

222

Brocade Mobility Access Point System Reference Guide

53-1003100-01

FIGURE 108

Profile - Environmental Sensor screen

Set the following Light Sensor settings for the AP8132’s sensor module:.

Enable or disable the following Environmental Sensors:

Enable Light Sensor

Select this option to enable the light sensor on the module. This setting is enabled by default. The
light sensor reports whether the access point has its light sensor powered on or off.

Polling Time to Determine
if Light is On/Off

Define an interval in Seconds (2 - 201) or Minutes (1 - 4) for the sensor module to poll its
environment to assess light intensity to determine whether lighting is on or off. The default polling
interval is 10 seconds. Light intensity is used to determine whether the access point’s deployment
location is currently populated with clients.

Shutdown WLAN Radio at
Low Limit of Light
Threshold

Select this option to power off the AP8132’s radios if the light threshold falls below the set
threshold. If enabled, select All (both AP8132 radios), radio-1 or radio-2.

Low Limit of Light
Threshold

Set the low threshold limit (from 0 - 1,000 lux) to determine whether the lighting is off in the
AP8132’s deployment location. The default is 100.

High Limit of Light
Threshold

Set the upper threshold limit (from 100 - 10,000 lux) to determine whether the lighting is on in the
AP8132’s deployment location. The default is 500.

Enable Temperature
Sensor

Select this option to enable the module’s temperature sensor. Results are reported back to the
access point’s Environment screens within the Statistics node. This setting is enabled by default.

Enable Motion Sensor

Select this option to enable the module’s motion sensor. Results are reported back to the access
point’s Environment screens within the Statistics node. This setting is enabled by default.

Enable Humidity Sensor

Select this option to enable the module’s humidity sensor. Results are reported back to the access
point’s Environment screens within the Statistics node. This setting is enabled by default.