Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 396)

386 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
FIGURE 214 Device Overrides - Advanced Profile MINT screen - IP (Add)
Set the following Link IP parameters to complete the MINT network address configuration:
IP Define or override the IP address used by peer access points for interoperation when
supporting the MINT protocol.
Routing Level Use the spinner control to define or override a routing level of either 1 or 2.
Listening Link Specify a listening link of either 0 or 1. UDP/IP links can be created by configuring a matching
pair of links, one on each end point. However, that is error prone and doesn’t scale. So UDP/IP
links can also listen (in the TCP sense), and dynamically create connected UDP/IP links when
contacted.
Port To specify a custom port for MiNT links, select this option and use the spinner control to define
or override the port number from 1 - 65,535.
Forced Link Select this option to specify the MiNT link as a forced link. This setting is disabled by default.
Link Cost Use the spinner control to define or override a link cost from 1 - 10,000. The default value is
100.