Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 787)

Brocade Mobility Access Point System Reference Guide 777
53-1003100-01
13
PPPoE
Access Point Statistics
The PPPoE statistics screen displays stats derived from the AP’s access to high-speed data and
broadband networks. PPPoE uses standard encryption, authentication, and compression methods
as specified by the PPPoE protocol. PPPoE enables access points to establish a point-to-point
connection to an ISP over existing Ethernet interface.
To review a selected access point’s PPPoE statistics:
1. Select the Statistics menu from the Web UI.
2. Select System from the navigation pane (on the left-hand side of the screen). Expand a RF
Domain and select one of its connected access points.
3. Select PPPoE.
FIGURE 49 Access Point - PPPoE screen
The Configuration Information field screen displays the following:
Refresh Select the Refresh button to update the screen’s statistics counters to their latest values.
Shutdown Displays whether a high speed client mode point-to-point connection has been enabled using
the PPPoE protocol.
Service Lists the 128 character maximum PPPoE client service name provided by the service provider.
DSL Modem Network
(VLAN) Displays the PPPoE VLAN (client local network) connected to the DSL modem. This is the local
network connected to DSL modem.
Authentication Type Lists authentication type used by the PPPoE client whose credentials must be shared by its
peer access point. Supported authentication options include None, PAP, CHAP, MSCHAP, and
MSCHAP-v2.