Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 317)

Brocade Mobility Access Point System Reference Guide 307
53-1003100-01
5
Select a target device from the device browser in the lower, left-hand, side of the UI.
Select Network to expand its sub menu options.
Select OSPF.
FIGURE 158 Device Overrides - Network - OSPF Settings screen
Enable/disable OSPF and provide the following dynamic routing settings:
Enable OSPF Select this option to enable OSPF for this access point. OSPF is disabled by default.
Router ID Select this option to define a router ID (numeric IP address) for this access point. This ID must be
established in every OSPF instance. If not explicitly configured, the highest logical IP address is
duplicated as the router identifier. However, since the router identifier is not an IP address, it
does not have to be a part of any routable subnet in the network.
Auto-Cost Select this option to specify the reference bandwidth (in Mbps) used to calculate the OSPF
interface cost if OSPF is either STUB or NSSA. The default setting is 1.