Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 807)

Brocade Mobility Access Point System Reference Guide 797
53-1003100-01
13
To view an access point’s ARP statistics:
1. Select the Statistics menu from the Web UI.
2. Select System from the navigation pane (on the left-hand side of the screen). Expand a RF
Domain and select one of its connected access points.
3. Select Network and expand the menu to reveal its submenu items.
4. Select ARP Entries.
FIGURE 64 Access Point - Network ARP screen
The ARP Entries screen describes the following:
Route Entries
Network
The Route Entries screen displays the destination subnet, gateway, and interface for routing
packets to a defined destination. When an existing destination subnet does not meet the needs of
the network, add a new destination subnet, subnet mask and gateway.
To view route entries:
1. Select the Statistics menu from the Web UI.
2. Select System from the navigation pane (on the left-hand side of the screen). Expand a RF
Domain and select one of its connected access points.
3. Select Network and expand the menu to reveal its sub menu items.
IP Address Displays the IP address of the client resolved on behalf of the access point.
ARP MAC Address Displays the MAC address corresponding to the IP address being resolved.
Type Lists the type of ARP entry.
VLAN Displays the system assigned VLAN ID where an IP address was found.
Refresh Select the Refresh button to update the screen’s statistics counters to their latest values.