Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 279)

Brocade Mobility Access Point System Reference Guide 269
53-1003100-01
5
12. Select OK to save the changes made to the port channel Basic Configuration. Select Reset to
revert to the last saved configuration.
13. Select the Security tab.
FIGURE 137 Device Overrides - Port Channels - Security tab
14. Refer to the Access Control field. As part of the port channel’s security configuration, Inbound
IP and MAC address firewall rules are required.
Use the Inbound IP Firewall Rules and Inbound MAC Firewall Rules drop-down menus to select
firewall rules to apply to this profile’s port channel configuration.
The firewall inspects IP and MAC traffic flows and detects attacks typically not visible to traditional
wired firewall appliances.
If a firewall rule does not exist suiting the data protection needs of the target port channel
configuration, select the Create icon to define a new rule configuration or the Edit icon to modify an
existing firewall rule configuration. For more information, see Wireless Firewall on page 8-531.