Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 629)

Brocade Mobility Access Point System Reference Guide 619
53-1003100-01
10
FIGURE 3 Management Policy - Access Control screen
4. Set the following parameters required for Telnet access:
5. Set the following parameters required for SSH access:
Enable Telnet Select the check box to enable Telnet device access. Telnet provides a command
line interface to a remote host over TCP. Telnet provides no encryption, but it does
provide a measure of authentication. Telnet access is disabled by default.
Telnet Port Set the port on which Telnet connections are made (1 - 65,535). The default port is
23. Change this value using the spinner control or by entering the port number in
the field.
Enable SSHv2 Select the check box to enable SSH device access. SSH (Secure Shell) version 2,
like Telnet, provides a command line interface to a remote host. SSH transmissions
are encrypted and authenticated, increasing the security of transmission. SSH
access is disabled by default.
SSHv2 Port Set the port on which SSH connections are made. The default port is 22. Change
this value using the spinner control or by entering the port number in the field.