Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 318)

308 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
Set the following OSPF Overload Protection settings:
Set the following Default Information:
Refer to the Route Redistribution table to set the types of routes that can be used by OSPF.
Select the + Add Row button to populate the table. Set the Route Type used to define the
redistributed route. Options include connected, kernel and static.
Select the Metric Type option to define the exterior metric type (1 or 2) used with the route
redistribution. Select the Metric option to define route metric used with the redistributed route.
Use the OSPF Network table to define networks (IP addresses) to connect using dynamic routes.
Select the + Add Row button to populate the table. Add the IP address and mask of the network(s)
participating in OSPF. Additionally, define the OSPF area (IP address) to which the network belongs.
Set an OSPF Default Route Priority (1 - 8,000) as the priority of the default route learnt from OSPF.
Click the Clear button next to the Clear OSPF Process field to clear all OSPF routing entries.
Select the Area Settings tab.
An OSPF Area contains a set of routers exchanging Link State Advertisements (LSAs) with others in
the same area. Areas limit LSAs and encourage aggregate routes.
Passive Mode on All
Interfaces When selected, all layer 3 interfaces are set as an OSPF passive interface. This setting is
disabled by default.
Passive Removed If enabling Passive Mode on All Interfaces, use the spinner control to select VLANs (by numeric
ID) as OSPF non passive interfaces. Multiple VLANs can be added to the list.
Passive Mode If disabling Passive Mode on All Interfaces, use the spinner control to select VLANs (by numeric
ID) as OSPF passive interfaces. Multiple VLANs can be added to the list.
VRRP Mode Check Select this option to enable checking VRRP state. If the interface’s VRRP state is not Backup,
then the interface is published via OSPF.
Number of Routes Use the spinner controller to set the maximum number of OSPN routes permitted. The available
range is from 1 - 4,294,967,295.
Retry Count Set the maximum number of retries (OSPF resets) permitted before the OSPS process is shut
down. The available range is from 1 - 32. The default setting is 5.
Retry Time Out Set the duration (in seconds) the OSPF process remains off before initiating its next retry. The
available range is from 1 - 3,600 seconds. The default is 60 seconds.
Reset Time Set the reset time (in seconds) that, when exceeded, changes the retry count is zero. The
available range is from 1 - 86,400. The default is 360 seconds.
Originate Select this option to make the default route a distributed route. This setting is disabled by
default.
Always Enabling this setting continuously maintains a default route, even when no routes appear in the
routing table. This setting is disabled by default.
Metric Type Select this option to define the exterior metric type (1 or 2) used with the default route.
Route Metric Select this option to define route metric used with the default route. OSPF uses path cost as its
routing metric. It’s defined by the speed (bandwidth) of the interface supporting given route.