Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 492)

482 Brocade Mobility Access Point System Reference Guide
53-1003100-01
6
Mesh QoS helps ensure each mesh point on thenetwork receives a fair share of the overall
bandwidth, either equally or as per the proportion configured. Packets directed towards clients are
classified into categories such as video, voice and data. Packets within each category are
processed based on the weights defined for each mesh point.
The Quality of Service screen displays a list of Mesh QoS policies available to mesh points. Each
Mesh QoS policy can be selected to edit its properties. If none of the exiting Mesh QoS policies
supports an ideal QoS configuration for the intended data traffic of this mesh point, select the Add
button to create new policy. Select an existing Mesh QoS policy and select Edit to change the
properties of the Mesh QoS policy.
To define a Mesh QoS policy:
1. Select Configuration.
2. Select Wireless.
3. Select Mesh QoS Policy to display existing Mesh QoS policies.
FIGURE 43 Mesh QoS Policy (QoS) screen
4. Refer to the following configuration data for existing Smart RF policies:
Mesh QoS Policy Displays the name of each configured mesh QoS policy.
Mesh Tx Rate Limit Displays whether or not a Mesh Tx Rate Limit is enabled for each Mesh QoS policy. This indicates
rate limiting is enabled or disabled for all data received from any mesh point in the mesh. When the
rate limit is enabled a green check mark is displayed, when it is disabled a red X is displayed.