Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 302)

292 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
Set the following General Settings for an L2TPv3 profile configuration:
Select the L2TP Tunnel tab.
FIGURE 149 Device Overrides - Network - L2TPv3 screen, T2TP tunnel tab
Set the following for an L2TPv3 profile configuration:
Host Name Define a 64 character maximum hostname to specify the name of the host that sent tunnel
messages. Tunnel establishment involves exchanging 3 message types (SCCRQ, SCCRP and SCCN)
with the peer. Tunnel IDs and capabilities are exchanged during the tunnel establishment with the
host.
Router ID Set either the numeric IP address or the integer used as an identifier for tunnel AVP messages. AVP
messages assist in the identification of a tunnelled peer.
UDP Listen Port Select this option to set the port used for listening to incoming traffic. Select a port from 1,024 -
65,353.
Tunnel Bridging Select this option to enable or disable bridge packets between two tunnel end points. This setting is
disabled by default.
Name Displays the name of each listed L2TPv3 tunnel assigned upon creation.
Local IP Address Lists the IP address assigned as the local tunnel end point address, not the interface IP address.
This IP is used as the tunnel source IP address. If this parameter is not specified, the source IP
address is chosen automatically based on the tunnel peer IP address.
MTU Displays the maximum transmission unit (MTU) size for each listed tunnel. The MTU is the size (in
bytes) of the largest protocol data unit that the layer can pass between tunnel peers.
Use Tunnel Policy Lists the L2TPv3 tunnel policy assigned to each listed tunnel.
Local Hostname Lists the tunnel specific hostname used by each listed tunnel. This is the hostname advertised in
tunnel establishment messages.
Local Router ID Specifies the router ID sent in the tunnel establishment messages.