Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 284)

274 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
If required, select a radio configuration and select the Edit button to modify or override portions of
its configuration.
FIGURE 140 Device Overrides - Access Point Radio Settings tab
The Radio Settings tab displays by default.
RF Mode Displays whether each listed radio is operating in the 802.11a/n or 802.11b/g/n radio band. If the
radio is a dedicated sensor, it will be listed as a sensor to define the radio as not providing typical
WLAN support. If the radio is a client bridge, it will be listed as a client bridge and does not provide
typical WLAN support. The radio band is set from within the Radio Settings tab.
Channel Lists the channel setting for the radio. Smart is the default setting. If set to smart, the access point
scans non-overlapping channels listening for beacons from other access points. After the channels
are scanned, it selects the channel with the fewest access points. In the case of multiple access
points on the same channel, it will select the channel with the lowest average power level.
Transmit Power Lists the transmit power for each radio.
Overrides Click the Clear to clear overrides made to this radio interface. This field is blank if there are no
overrides for this radio.