Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 130)

120 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
15. Define the following Session parameters:
16. Select OK to save the changes within the T2TP Tunnel screen. Select Reset to revert the screen
to its last saved configuration.
17. Select the Manual Session tab.
After successful tunnel connection and establishment, individual sessions can be created. Each
session is a single data stream. After successful session establishment, data corresponding to that
session (pseudowire) can be transferred. If a session is down, the pseudowire associated with it is
shut down as well.
FIGURE 36 Network - L2TPv3 screen - Manual Session tab
Name Enter a 31 character maximum session name. There is no idle timeout for a tunnel. A tunnel is not
usable without a session and a subsequent session name. The tunnel is closed when the last
session tunnel session is closed.
Pseudowire ID Define a psuedowire ID for this session. A pseudowire is an emulation of a layer 2
point-to-point connection over a packet-switching network (PSN). A pseudowire was developed out
of the necessity to encapsulate and tunnel layer 2 protocols across a layer 3 network.
Traffic Source Type Lists the type of traffic tunnelled in this session.
Traffic Source Value Define a VLAN range to include in the tunnel session. Available VLAN ranges are from
1 - 4,094.
Native VLAN Select this option to provide a VLAN ID that will not be tagged in tunnel establishment and packet
transfer.