Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 364)

354 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
FIGURE 193 Profile Override Security - Bridge NAT screen
5. Review the following Bridge NAT configurations to determine whether a new Bridge NAT
configuration requires creation or an existing configuration overridden or removed:
6. Select Add to create a new Bridge VLAN configuration, Edit to modify or override an existing
configuration or Delete to remove a configuration.
ACL Lists the ACL applying IP address access/deny permission rules to the Bridge NAT configuration.
Interface Lists the communication medium (outgoing layer 3 interface) between source and destination points. This
is either the access point’s pppoe1 or w wan1 interface or the VLAN used as the redirection interface
between the source and destination.
NAT Pool Lists the names of existing NAT pools used with the Bridge NAT configuration. This displays only when
Overload Type is NAT Pool.
Overload IP Lists the address used globally and collectively for numerous local addresses.
Overload Type Lists the overload type used with the listed IP ACL rule. Set as either NAT Pool, One Global Address or
Interface IP Address.
ACL Precedence Lists the administrator assigned priority set for the ACL. The lower the value listed, the higher the priority
assigned to this ACL.