Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 574)

564 Brocade Mobility Access Point System Reference Guide
53-1003100-01
8
FIGURE 22 WIPS Signature Configuration screen
19. If adding a new WIPS signature, define a Name to distinguish it from others with similar
configurations. The name cannot exceed 64 characters.
20. Set the following network address information for a new or modified WIPS Signature:
Enable Signature Select the radio button to enable the WIPS signature for use with the profile. The default
signature is enabled.
BSSID MAC Define a BSS ID MAC address used for matching and filtering with the signature.
Source MAC Define a source MAC address for the packet examined for matching, filtering, and
potential device exclusion using the signature.
Destination MAC Set a destination MAC address for a packet examined for matching, filtering, and potential
device exclusion using the signature.
Frame Type to Match Use the drop-down menu to select a frame type for matching with the WIPS signature.
Match on SSID Sets the SSID used for matching. Ensure it’s specified properly or the SSID won’t be
properly filtered.
SSID Length Set the character length of the SSID used for matching purposes. The maximum length is
32 characters.