Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 66)

56 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
However, an access point’s RF Domain configuration may need periodic refinement from its original
RF Domain designation. Unlike a RFS series wireless controller, an access point supports just a
single RF domain. Thus, administrators should be aware that overriding an access point’s RF
Domain configuration results in a separate configuration that must be managed in addition to the
RF Domain configuration. Thus, a configuration should only be overridden when needed. For more
information, see
RF Domain Overrides on page 5-242 .
The access point’s RF Domain can have a WIPS sensor configuration applied. For more information
on defining a WIPS sensor configuration for use with the access point’s RF Domain, see
RF Domain
Sensor Configuration on page 5-57 .
To set a RF Domain configuration:
1. Select the Configuration tab from the Web UI.
2. Select Devices.
3. Select RF Domains from the options on left-hand side of the UI.
The RF Domain Basic Configuration tab displays by default with the access point RF Domain
activated.
FIGURE 1 RF Domain - Basic Configuration tab