Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 43)

Brocade Mobility Access Point System Reference Guide 33
53-1003100-01
3
LAN Configuration
Advanced Setup Wizard
Use the LAN Configuration screen to configure the parameters required for setting a Local Area
Network (LAN) on the access point.
FIGURE 15 Initial Setup Wizard - LAN Configuration screen for Advanced Setup Wizard
1. Set the following DHCP and Static IP Address/Subnet information for the LAN interface:
• Use DHCP - Select the option to enable an automatic network address configuration using
DHCP server.
• Static IP Address/Subnet - Enter an IP Address and a subnet for the access point's LAN
interface. If Use DHCP is selected, this field is not available. When selecting this option,
define the following DHCP Server and Domain Name Server (DNS) resources, as those
fields will become enabled on the bottom portion of the screen.
• Use on-board DHCP server to assign IP addresses to wireless clients - Select the
check box to enable the access point’s DHCP server to provide IP and DNS information
to clients on the LAN interface.