Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 145)

Brocade Mobility Access Point System Reference Guide 135
53-1003100-01
5
FIGURE 45 Network - Interface Settings tab
17. Review existing Interface Settings using:
18. Select the Add button to define a new set of virtual interface basic settings, or Edit to update
the settings of an existing virtual interface configuration.
Name Displays the name defined for the interface configuration.
Type Displays the type of interface.
Description Lists each interface’s 32 character maximum description.
Admin Status A green check mark defines the interface as active and currently enabled with the profile. A red
“X” defines the interface as currently disabled and not available for use.
VLAN Lists the VLAN IDs set for each listed OSPF route virtual interface.
IP Address Displays the IP addresses defined as virtual interfaces for dynamic OSPF routes. Zero config and
DHCP can be used to generate route addresses, or a primary and secondary address can be
manually provided.