Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 641)

Brocade Mobility Access Point System Reference Guide 631
53-1003100-01
11
NOTE
Leave the Source, Device and Mobile Unit fields at the default setting of 00:00:00:00:00:00 to allow
all MAC addresses.
3. Select the Add to Active Filters button to create a new filter and add it to the Active Event Filters
table. When added, the filter uses the configuration defined in the Customize Event Filters
field.
4. Refer to the Active Event Filters table to set the following parameters:
To activate all the events in the Active Events Filters table, select the Enable All Events button. To
stop event generation, select Disable All Events.
To enable an event in the Active Event Filters table, select the event, then select the Activate
Defined Filter button.
NOTE
Filters cannot be persisted across sessions. They must be created every time a new session is
established.
Select View Events from the upper, left-hand, side of the Fault Management browser.
FIGURE 2 Fault Management - View Events screen
Use the View Events screen to track and troubleshoot events using source and severity levels
defined in the configure events screen.