Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 271)

Brocade Mobility Access Point System Reference Guide 261
53-1003100-01
5
FIGURE 131 Device Overrides - Virtual Interfaces screen
Review the following parameters unique to each Virtual Interface configuration to determine
whether a parameter override is warranted:
Once the configurations of existing Virtual Interfaces have been reviewed, determine whether a
new interface requires creation, or an existing Virtual Interface requires edit (override) or deletion.
Select Add to define a new Virtual Interface configuration, Edit to modify or override the
configuration of an existing Virtual Interface or Delete to permanently remove a selected Virtual
Interface.
Name Displays the name of each listed Virtual Interface assigned when it was created. The name is from
1 - 4094, and cannot be modified as part of a Virtual Interface edit.
Type Displays the type of Virtual Interface for each listed interface.
Description Displays the description defined for the Virtual Interface when it was either initially created or
edited.
Admin Status A green check mark defines the listed Virtual Interface configuration as active and enabled with its
supported profile. A red “X” defines the Virtual Interface as currently disabled. The interface status
can be modified when a new Virtual Interface is created or an existing one modified.
VLAN Displays the numerical VLAN ID associated with each listed interface.
IP Address Defines whether DHCP was used to obtain the primary IP address used by the Virtual Interface
configuration.