Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 228)

218 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
Select the VLAN tab to display the link IP VLAN information shared by the devices managed by the
MINT configuration.
The VLAN tab displays the VLAN, Routing Level, Link Cost, Hello Packet Interval and Adjacency Hold
Time managed devices use to securely communicate amongst one another.
FIGURE 105 Advanced Profile Configuration - MINT Protocol screen - VLAN tab
Select Add to create a new VLAN link configuration or Edit to modify an existing configuration.
NOTE
If creating a mesh link between two access points in Standalone AP mode, you will need to ensure
a VLAN is available to provide the necessary MINT link between the two Standalone APs.