Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 598)

588 Brocade Mobility Access Point System Reference Guide
53-1003100-01
9
FIGURE 11 Static Bindings Add screen
11. Define the following General parameters required to complete the creation of the static binding
configuration:
Client Identifier Type Use the drop-down menu whether the DHCP client is using a Hardware Address or Client
Identifier as its identifier type with a DHCP server.
Value Provide a hardware address or client identifier value to help differentiate the client from
other client identifiers.
IP Address Set the IP address of the client using this host pool. Select Alias to use a network alias
with the IP address configuration. For more information see Alias on page 7-520.
Domain Name Provide a domain name of the current interface. Domain names aren’t case sensitive and
can contain alphabetic or numeric letters or a hyphen. A fully qualified domain name
(FQDN) consists of a hostname plus a domain name. For example,
computername.domain.com. Select Alias to use a string alias with the domain name
configuration. For more information see Alias on page 7-520.
Boot File Enter the name of the boot file used with this pool. Boot files (Boot Protocol) can be used
to boot remote systems over the network. BOOTP messages are encapsulated inside UDP
messages so requests and replies can be forwarded. Each DHCP network pool can use a
different file as needed
BOOTP Next Server Provide the numerical IP address of the server providing BOOTP resources. Select Alias to
use a network alias with the BOOTP Next Server configuration. For more information see
Alias on page 7-520.
Client Name Provide the name of the client requesting DHCP Server support.