Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 402)

392 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
FIGURE 219 Event Policy screen
Ensure the Activate Event Policy option is selected to enable the screen for configuration. This
option needs to remain selected to apply the event policy configuration to the access point profile.
Refer to the Select Event Module drop-down menu on the top right-hand side of the screen and
select an event module used to track the occurrence of each list event.
Review each event and select (or deselect) the SNMP, Syslog, Forward to Switch or Email
Notification option as required for the event. Map an existing policy to a device profile as needed.
Select Profile from the Map drop-down menu in the lower-left hand side of the screen. Expand the
list of device profiles available, and apply the event policy as required.
Select OK to save the changes. Select Reset to revert to the last saved configuration. Delete
obsolete rows as needed.