Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 110)

100 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
FIGURE 25 Access Point Radio - WLAN Mapping tab
12. Refer to the WLAN Mapping/Mesh Mapping field to set WLAN BSSID assignments for an
existing access point deployment.
Administrators can assign each WLAN its own BSSID. If using a single-radio access point, there are
8 BSSIDs available. If using a dual-radio access point there are 8 BSSIDs for the 802.11b/g/n
radio and 8 BSSIDs for the 802.11a/n radio.
Each supported access point model can support up to 8 BSS IDs.
13. Select Advanced Mapping to list all the available BSSIDs for the radio.
14. Select Create New WLAN to open a dialog where a new WLAN are created.
15. Select Create New MeshPoint to open a dialog where new Mesh Points are created.
16. Select the OK button located at the bottom right of the screen to save the changes to the WLAN
Mapping. Select Reset to revert to the last saved configuration.
17. Select the Legacy Mesh tab.