Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 295)

Brocade Mobility Access Point System Reference Guide 285
53-1003100-01
5
FIGURE 145 Profile Interface - PPPoE screen
26. Use the Basic Settings field to enable PPPoE and define a PPPoE client:
Enable PPPoE Select Enable to support a high speed client mode point-to-point connection using the PPPoE
protocol. The default setting is disabled.
Service Enter the 128 character maximum PPPoE client service name provided by the service provider.
DSL Modem Network
(VLAN) Use the spinner control to set the PPPoE VLAN (client local network) connected to the DSL modem.
This is the local network connected to DSL modem. The available range is 1 - 4,094. The default
VLAN is VLAN1
Client IP Address Provide the numerical (non hostname) IP address of the PPPoE client.