Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 193)

Brocade Mobility Access Point System Reference Guide 183
53-1003100-01
5
15. Refer to the following to determine whether a new Dynamic NAT configuration requires
creation, edit or deletion:
16. Select Add to create a new Dynamic NAT configuration, Edit to modify an existing configuration
or Delete to permanently remove a configuration.
FIGURE 82 Profile Security - Source ACL List screen
Source List ACL Lists the ACL defining packet selection criteria for the NAT configuration. NAT is applied only on
packets which match a rule defined in the access list. These addresses (once translated) are not
exposed to the outside world when the translation address is used to interact with the remote
destination.
Network Displays Inside or Outside NAT as the network direction for the dynamic NAT configuration.
Interface Lists the VLAN (from 1 - 4094) used as the communication medium between the source and
destination points within the NAT configuration.
Overload Type Lists the Overload Type used with the listed IP ACL rule. Options include NAT Pool, One Global
Address and Interface IP Address. The default setting is Interface IP Address.
NAT Pool Displays the name of an existing NAT pool used with the NAT configuration.
Overload IP Enables the use of one global address for numerous local addresses.
ACL Precedence Lists the administrator assigned priority set for the listed source list ACL. The lower the value listed,
the higher the priority assigned to this ACL rule.