Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 763)

Brocade Mobility Access Point System Reference Guide 753
53-1003100-01
13
FIGURE 32 Access Point - Device screen
The System field displays the following:
The System Resources field displays the following:
Model Number Displays the model of the selected access point to help distinguish its exact SKU and country
of operation.
Serial Number Displays the numeric serial number set for the access point.
Version Displays the software (firmware) version on the access point.
Boot Partition Displays the boot partition type.
Fallback Enabled Displays whether this option is enabled. This method enables a user to store a known legacy
version and a new version in device memory. The user can test the new software, and use an
automatic fallback, which loads the old version on the access point if the new version fails.
Fallback Image
Triggered Displays whether the fallback image was triggered. The fallback image is an old version of a
known and operational software stored in device memory. This allows a user to test a new
version of software. If the new version fails, the user can use the old version of the software.
Next Boot Designates this version as the version used the next time the access point is booted.
Available Memory (MB) Displays the available memory (in MB) available on the access point.
Total Memory (MB) Displays the access point’s total memory.
Currently Free RAM Displays the access point’s free RAM space. If its very low, free up some space by closing
some processes.
Recommended Free
RAM Displays the recommended RAM required for routine operation.