Passpoint policy – Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 498
488
Brocade Mobility Access Point System Reference Guide
53-1003100-01
6
FIGURE 45
Mesh QoS Policy - Multimedia Optimizations screen
16. Set the following Accelerated Multicast settings:
17. Select OK when completed to update the Mesh Multimedia Optimizations settings. Select
Reset to revert to the last saved configuration.
Passpoint Policy
A Passpoint Policy provides a mechanism by which devices can select the correct network by
querying for information from the available networks and then deciding which network to associate
with. A Passpoint policy is associated to a WLAN to enable the WLAN to provide hotspot services.
Disable Multicast
Streaming
Select this option to disable Multicast Streaming on the mesh point.
Automatically Detect
Multicast Streams
Select this option tto have bridged multicast packetsconverted to unicast to provide better overall
airtime utilization and performance. The administrator can either have the system automatically
detect multicast streams and convert all detected multicast streams to unicast, or specify which
multicast streams are to be converted to unicast. When the stream is converted and being queued
up for transmission, there are a number of classification mechanisms that can be applied to the
stream and the administrator can select what type of classification they would want.
Manually Configure
Multicast Addresses
Select this option and specify a list of multicast addresses and classifications. Packets are
accelerated when the destination addresses matches.