Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 227)

Brocade Mobility Access Point System Reference Guide 217
53-1003100-01
5
FIGURE 104 Advanced Profile Configuration- MINT Protocol screen - Add IP MiNT Link field
Set the following Link IP parameters to complete the MINT network address configuration:
IP Define the IP address used by peer access points for interoperation when supporting the MINT
protocol.
Port Select this option to specify a custom port for MiNT links. Use the spinner control to define the
port number (from 1 - 65,535).
Routing Level Use the spinner control to define a routing level of either 1 or 2.
Listening Link Specify a listening link of either 0 or 1. UDP/IP links can be created by configuring a matching
pair of links, one on each end point. However, that is error prone and does not scale. So UDP/IP
links can also listen (in the TCP sense), and dynamically create connected UDP/IP links when
contacted.
Forced Link Select this option to specify the MiNT link as a forced link.
Link Cost Use the spinner control to define a link cost from 1 - 10,000. The default value is 100.
Hello Packet Interval Set an interval in either Seconds (1 - 120) or Minutes (1 - 2) for the transmission of hello
packets. The default interval is 15 seconds.
Adjacency Hold Time Set a hold time interval in either Seconds (2 - 600) or Minutes (1 - 10) for the transmission of
hello packets. The default interval is 46 seconds.
IPSec Secure Select this option to use a secure link for IPSec traffic. This setting is disabled by default. When
enabled, both the header and the traffic payload are encrypted.
IPSec GW Define either an IP address or hostname for the IPSec gateway.