Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 911)

Brocade Network Advisor IP User Manual 857
53-1002947-01
Software image management
28
The Schedule Backup dialog box displays, as shown in Figure 309 .
FIGURE 309 Schedule Backup dialog box
3. Select the automatic software image backup task from the list, and click Edit.
The Edit Automatic Software Image Backup dialog box displays, as shown in Figure 310 .
FIGURE 310 Edit Automatic Software Image Backup dialog box
4. Disable the scheduled backup or modify the frequency and time.
Refer to “Scheduling a configuration backup” on page 805 for information about how to
schedule a configuration backup.
5. Click OK.
Deploying software images to products
The Management application stores previously imported software images. These software images
can be placed in a software image payload and deployed to products using the Configuration
Wizard.
For a HyperEdge stack, you must deploy the ICX 6610 and ICX 6450 software images to the active
master unit separately. Make sure that both software images have the same software image
version. When both software image upgrades are complete, reload the HyperEdge stack. The
master unit upgrades the software images to the appropriate member units.
Deleting software images from the Management application
If a software image stored in the Management application must be deleted, perform the following
steps.
1. Click the Software Images tab on the Firmware Management dialog box.
2. Select the software image that you want to delete.
3. Click the Delete button.
A confirmation warning displays.
4. Click Yes to continue with the delete, or No to cancel it.