Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 896)

842 Brocade Network Advisor IP User Manual
53-1002947-01
Monitoring configurations
27
f. Edit the parameter by entering the variable or character string you want to use for the
parameter in place of the name variable.
NOTE
Each parameter must be unique. The Management application does not check for
duplicate parameters.
show interface ethernet $
In the example,
show interface ethernet
is the CLI command,
port
is the parameter
variable,
SLOT_PORT
is the parameter type, and
[Slot#]/Port#
is the format for the port
number.
g. (Optional) Select a template from the CLI Templates folder and click the right arrow to
include it in the configuration.
This allows you to deploy more than one template to a device in a single deployment. Only
templates defined in the Management application display. This list only displays when
there is at least one user-defined CLI template.
6. Click the Parameters tab and complete the following steps.
FIGURE 308 CLI Template dialog box - Parameters tab
a. Select the Always prompt for parameter review/edit during manual deployment check to
display the Parameter tab in the Prompt dialog box during manual deployment.
Clear to not display the Parameter tab in the Prompt dialog box during manual
deployment.
When selected, the Parameter tab displays in the Prompt dialog box during manual
deployment even if you filled in all parameter values on the Parameters tab of the CLI
Template dialog box.
b. Select one of the following options from the Mode list for the parameter import mode.
• Same Values for each Target — Select to set the same values for all selected targets.
• Different Values for each Target — Select to set individual values for the selected
targets.