Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 1274)

1220 Brocade Network Advisor IP User Manual
53-1002947-01
Pseudo events
39
Pseudo events
A pseudo event is a combination of different SNMP traps that you decide would constitute a single
event. For example, there are two separate SNMP traps for link up and link down occurrences. You
might decide that these two occurrences should be just one event.
Displaying pseudo event definitions
To display the properties of a pseudo event definition, complete the following steps.
1. Select Monitor > Event Processing > Pseudo Events.
The Pseudo Events dialog box, shown in Figure 485 , displays.
FIGURE 485 Pseudo Events dialog box
2. To view additional information for a definition, select a definition from the list. Additional
information displays in the Details of Selected Pseudo Event list at the bottom of the dialog
box.
Creating pseudo event definitions
To create a pseudo event definition, complete the following steps.
1. Select Monitor > Event Processing > Pseudo Events.
The Pseudo Events dialog box, shown in Figure 485 , displays.
2. Click Add.
3. The Identification pane of the Add Pseudo Event dialog box displays.
4. Type a unique name for the pseudo event. Duplicate names are not allowed.
5. Select the Enabled check box to enable the pseudo event or clear the check box to disable the
pseudo event.
6. Click Next.
The Policy pane of the Add Pseudo Event dialog box, shown in Figure 486 , displays.