Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 1437)

Brocade Network Advisor IP User Manual 1383
53-1002947-01
CLI Templates
G
TABLE 43 Network OS – Configure RX Symbol Errors Monitor
Feature Description CLI Commands
Network OS This template is used to configure
threshold and alert values for RX
Symbol Errors Monitoring.
Possible values for timebase are
day, hour, minute and none.
Buffer value cannot be more than
average of high plus low threshold.
Supported Values for High and Low
Threshold Action Parameters are
email, raslog, all, and none. threshold-monitor interface custom type Ethernet area
SymbolErrors threshold timebase $
high-threshold $
low-threshold $ buffer
$
threshold-monitor interface custom type Ethernet area
SymbolErrors alert above highthresh-action
$ lowthresh-action
$
threshold-monitor interface custom type Ethernet area
SymbolErrors alert below highthresh-action
$ lowthresh-action
$
threshold-monitor interface apply custom-monitoring
TABLE 44 Network OS – Configure Standard L2 Access List
Feature Description CLI Commands
ACL This template is used to configure
standard L2 ACL on Network OS
products running 3.0 or later. mac access-list standard $
deny $ $
permit $ $
permit any
TABLE 45 Network OS – Create CoS Mutation Map
Feature Description CLI Commands
QoS This template is used to create the
CoS-to-CoS mutation QoS map
name qos map cos-mutation $
$
TABLE 46 Network OS – Create LLDP Profile
Feature Description CLI Commands
QoS This template is used to create LLDP
profile and configure LLDP profile
parameters protocol lldp
profile $
description $
hello $
multiplier $
advertise dcbx-fcoe-logical-link-tlv
advertise dcbx-fcoe-app-tlv