Fabric os layer 2 acl configuration – Brocade Network Advisor IP User Manual v12.1.0 User Manual
Page 669
Brocade Network Advisor IP User Manual
615
53-1002947-01
Layer 2 access control list management
20
Fabric OS Layer 2 ACL configuration
NOTE
Only available for Fabric OS DCB products.
This section provides procedures for configuring a standard for extended Layer 2 ACL on a device,
assigning the Layer 2 ACL to an interface, as well as clearing Layer 2 ACL assignments from a
device.
Creating a standard Layer 2 ACL configuration (Fabric OS)
To create a standard Layer 2 ACL configuration, complete the following steps.
1. Select the device and select Configure > Security > Layer 2 ACL > Product.
The Device_Name - Layer 2 ACL Configuration dialog box displays.
2. Select New from the Add list.
The Device_Name - Layer 2 ACL Configuration dialog box displays.
FIGURE 214
Device_Name
- Layer 2 ACL Configuration (Standard) dialog box
3. Select Standard from the Type list.
4. Enter a name for the ACL in the Name field.
5. Enter a sequence number for the ACL in the Sequence field.
6. Select Permit or Deny from the Action list.
7. In the Source list, select one of the following options:
•
Any
•
MAC
Selecting MAC enables the Source field. Enter the source MAC address on which the
configuration filters traffic in the Source field.
8. Select the Count check box to enable counting.