Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 201)

Brocade Network Advisor IP User Manual 147
53-1002947-01
Flyover settings
6
Flyover settings
You can configure your system to display information for products and connections in a pop-up
window on the Connectivity Map.
Configuring flyovers
To display product and connection information in a pop-up window, complete the following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select Flyovers in the Category list.
3. Select the Enable flyover display check box to enable flyover display on your system.
4. Select the Include labels check box to include labels on flyover displays.
5. Add product properties you want to display on flyover by selecting the Product tab ( Figure 57 )
and completing the following steps.
FIGURE 57 Options dialog box (Flyovers pane, Product tab)
a. Select the protocol type from the Type list, if necessary.
b. Select each property you want to display in the product flyover from the Available
Properties table.
Depending on which protocol you select, some of the following properties may not be
available:
IP
c. Click the right arrow to move the selected properties to the Selected Properties table.
d. Use the Move Up and Move Down buttons to reorder the properties in the Selected
Properties table, if necessary.
The properties displayed in the Selected Properties table appear in the flyover display.
6. Remove product properties you do not want to display on flyover by selecting the property in the
Selected Properties table and clicking the left arrow.
7. Add connection properties you want to display on flyover by selecting the Connection tab
( Figure 58 ) and completing the following steps.
•
Display Name
•
IP Address
•
Status