Creating a service group – Brocade Network Advisor IP User Manual v12.1.0 User Manual
Page 718
664
Brocade Network Advisor IP User Manual
53-1002947-01
Layer 3 access control list policy
20
3. Click Close on the Service dialog box.
To finish configuring the advanced settings for the ACL, refer to
Creating a service group
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
•
“Creating an extended L3 ACL configuration”
•
“Editing an extended L3 ACL configuration”
•
“Copying an extended L3 ACL configuration”
•
“Creating an extended L3 ACL configuration”
•
“Editing an IPv6 L3 ACL configuration”
•
“Copying an IPv6 L3 ACL configuration”
To create a service group, complete the following steps.
1. Click the Service Groups tab.
2. Click Add.
The Add Service Group dialog box displays.
FIGURE 235
Add Service Group dialog box
3. Enter a name for the service group in the Name field.
4. To enter a range of ports, complete the following steps.
a. Enter the starting port number in the Start Port field.
b. Enter the ending port number in the End Port field.
c. Click the right arrow button to move the address range to the Selected table.