Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 1241)

Brocade Network Advisor IP User Manual 1187
53-1002947-01
SNMP traps
39
7. Click the View Recipients button to list the recipients that correspond to a selected fabric or
product from the Available list.
The Trap Recipients - Fabric dialog box or the Trap Recipients - IP address dialog box
(depending on which product you selected) displays a list of configured recipients.
8. Click OK.
The Management application registers the recipient IP address as an SNMP trap recipient.
The SNMP version and credentials from the SNMP profile (for example, SNMP v3) are
registered.
Removing a trap recipient from one or more switches
To remove a trap recipient from one or more switches, complete the following steps.
1. Select Monitor > SNMP Setup > Product Trap Recipients.
The SNMP Trap Recipients dialog box, shown in Figure 462 , displays.
2. Click Remove from the Action list.
3. Enter the IP address of the SNMP trap port (the recipient server) in the Recipient IP Address
field.
4. Select the fabric or switches from the Available list.
NOTE
For IP products, only switches are available to select.
5. Click OK.
The Management application removes the recipient from the managed switches.
SNMP trap forwarding
The SNMP Trap Forwarding dialog box allows the Management application to forward received
SNMP traps to product trap recipients.
You can use the SNMP Trap Forwarding feature to set up filters to determine which traps will be
forwarded. The filters can be one of the following:
• Severity of the trap
• Available products type
• Trap type
• Message types (application messages or pseudo events)
To forward SNMP traps, complete the following steps.
1. Select Monitor > SNMP Setup > Trap Forwarding.
The SNMP Trap Forwarding dialog box, shown in Figure 463 , displays.