Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 116)

62 Brocade Network Advisor IP User Manual
53-1002947-01
Default IP user credentials
4
• Enable Super User — The super user enable password configured on the device for Telnet
login. You can configure the super user enable password by using the enable
super-user-password CLI command. The super user enable password can be used to
authenticate users with the super user privilege configured on the device.
You can define more than one password for each password type. Discovery uses the passwords in
the order they are listed when it probes the devices.
Adding user credentials
To add default user names and passwords, complete the following steps.
1. Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
2. Click the Global Settings tab.
3. Click the Default Passwords tab.
FIGURE 14 Default Passwords
4. Enter a login prompt user name and password by selecting Read/Write Login Prompt from the
Credential Type list and completing the following steps.
FIGURE 15 Read/Write Login Prompt
a. Enter a unique label to identify the credentials in the Display Label field.
This label can be from 1 through 200 characters long, case sensitive, and allows all
printable ASCII characters.
b. Enter the user name in the User ID field.