Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 692)

638 Brocade Network Advisor IP User Manual
53-1002947-01
Layer 3 access control list policy
20
7. Choose one of the following options from the Destination list:
• To enter an IP address, select IP Address and complete the following steps:
a. Enter the destination IP address on which the ACL filters traffic in the IP Address list
and text field.
You can enter the IPv6 address in compressed (for example, you can compress
2001:db8:0:0:0:0:2:1 can be shortened to 2001:db8::2:1) or raw format.
b. Enter the prefix length (1 through 128) in the Prefix Length field.
• To select a network, select IP Address and choose a network from the list.
• To enter a host name, select Host and enter the destination host name on which the ACL
filters traffic in the Host list and text field.
8. Enter a VLAN identifier (valid values are from 1 to 4095) from the VLAN list.
9. Select the Log Enable check box to enable logging.
10. Click Advanced Settings to configure additional settings for the ACL configuration.
NOTE
You must configure advanced settings to create an extended Layer 3 ACL.
The L3 ACL Advanced Settings dialog box displays.
FIGURE 224 Add - L3 Advanced Settings dialog box (IPv6)
To configure additional settings, refer to “Configuring L3 ACL advanced settings” on page 645.
11. Click the right arrow button.
The new ACL displays in the ACL Entries list.
12. Repeat step 4 through step 11 to add additional entries.
13. Use the Up and Down arrow buttons to rearrange the ACLs in the ACL Entries list.
14. View the advanced settings for an ACL by selected the ACL in the ACL Entries list and clicking
View.
The L3 ACL Advanced Settings dialog box displays.
15. Click Close on the L3 ACL Advanced Settings dialog box to close.