Testing a configuration – Brocade Network Advisor IP User Manual v12.1.0 User Manual
Page 887
Brocade Network Advisor IP User Manual
833
53-1002947-01
Testing a configuration
27
•
Click Deploy to deploy the configuration to the selected targets. Click Yes on the
confirmation message.
If you selected the Prompt for additional targets during manual deployment check box, the
Target tab of the Deployment of Configuration_Name dialog box displays. Continue with
If the configuration contains parameters that must be defined, the Deployment of
Configuration_Name dialog box displays with a list of all parameters in the deployment. Go
to
.
6. Define additional targets for the deployment (refer to
), as needed.
7. Edit the mode and the parameter values (refer to
), as needed.
8. Click OK.
The Deployment Status dialog box displays, which allows you to view the progress and status of
the deployment.
Click Abort to stop the deployment.
NOTE
The abort action does not stop the tasks that have already started.
When deployment is complete, click Report to view the CLI Deployments Report.
9. Click Close to close the Deployment Status dialog box.
NOTE
Closing the Deployment Status dialog box does not stop deployment.
To check the results of the deployment in the Product CLI Report, refer to
on page 846. For details about valid and invalid responses when you deploy a
“Valid and invalid responses from devices”
Testing a configuration
To test a configuration, complete the following steps.
1. Select Configure > CLI Configuration.
The CLI Configuration dialog box displays.
2. Select the configuration you want to verify in the Templates table and click Verify.
3. Click Yes on the “Do you want to verify?” message to confirm.
If you selected the Prompt for additional targets during manual deployment check box, the
Target tab of the Deployment of Configuration_Name dialog box displays. Continue with
If the configuration contains parameters that must be defined, the Deployment of
Configuration_Name dialog box displays with a list of all parameters in the deployment. Go to
4. Define additional targets for the deployment (refer to
), as needed.