Editing a service group – Brocade Network Advisor IP User Manual v12.1.0 User Manual
Page 719
Brocade Network Advisor IP User Manual
665
53-1002947-01
Layer 3 access control list policy
20
5. To add a service to the group, complete the following steps.
a. Select one or more services to add to the group in the Services table.
b. Click the right arrow button to move the selected services to the Selected table.
6. To add a service group to the group, complete the following steps.
a. Select one or more service groups to add to the group in the Services table.
b. Click the right arrow button to move the selected service groups to the Selected table.
7. Click OK on the Add Service dialog box.
The Service dialog box, Service Group tab displays with the new group in the List of Service
Groups table.
8. Click Close on the Service dialog box.
To finish configuring the advanced settings for the ACL, refer to
Editing a service group
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
•
“Creating an extended L3 ACL configuration”
•
“Editing an extended L3 ACL configuration”
•
“Copying an extended L3 ACL configuration”
•
“Creating an extended L3 ACL configuration”
•
“Editing an IPv6 L3 ACL configuration”
•
“Copying an IPv6 L3 ACL configuration”
To edit a service, complete the following steps.
1. Click the Service Groups tab.
2. Select the service group you want to edit and click Edit.
The Edit Service Group dialog box displays.
3. To enter a range of ports, complete the following steps.
a. Enter the starting port number in the Start Port field.
b. Enter the ending port number in the End Port field.
c. Click the right arrow button to move the address range to the Selected table.
4. To add a service to the group, complete the following steps.
a. Select one or more services to add to the group in the Services table.
b. Click the right arrow button to move the selected services to the Selected table.
5. To add a service group to the group, complete the following steps.
a. Select one or more service groups to add to the group in the Services table.
b. Click the right arrow button to move the selected service groups to the Selected table.