Deleting cimom server credentials, Decommissioning an f-port – Brocade Network Advisor IP User Manual v12.1.0 User Manual
Page 503
Brocade Network Advisor IP User Manual
449
53-1002947-01
Port commissioning overview
14
Deleting CIMOM server credentials
1. Select Configure > Port Commissioning > Setup.
The Port Commissioning Setup dialog box displays (
2. Select one or more CIMOM server from the System List table and click the left arrow button.
The details for the last selected CIMOM server row displays in the Add/Edit System and
Credentials area.
3. Confirm that this is the CIMOM server you want to delete and click OK or Apply to delete the
CIMOM server from the Port Commissioning Setup dialog box.
When the deletion is complete, an application event displays in the Master Log detailing
success or failure.
Decommissioning an F-Port
NOTE
You must configure at least one CIMOM server (refer to
before you can decommission an F-Port.
NOTE
Fabric tracking must be enabled (refer to
on page 187) to maintain the
decommissioned port details (such as port type, device port wwn, and so on). Do not accept
changes in the Management application client.
1. Select the F-Port, then select Configure > Port Commissioning > Decommission > Port.
The Port Commission Confirmation dialog box displays.
2. Choose one of the following options:
•
Apply Default Settings (default) — Select to have the Management application contact all
registered CIMOM servers within the fabric affected by the action and obtains the status
from each CIMOM server. If all CIMOM servers are okay, the Management application
sends a CAL Request to decommission the port. If even one CIMOM server is not okay,
decommissioning fails.
•
Force — Select to force the port decommission. The Management application still contacts
all registered CIMOM servers within the fabric affected by the action, but forces the port
decommission regardless of the CIMOM server response.
NOTE
If the CIMOM server is not reachable or the credentials fail, F-Port decommission does not
occur.
3. Click OK on the Port Commission Confirmation dialog box.
While decommissioning is in progress, a down arrow icon displays next to the port icon in the
Product List. You can view the port commissioning results in the deployment reports (refer to
“Port commissioning deployment report”
When the decommission is complete, an application event displays in the Master Log detailing
success or failure.