Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 1223)

Brocade Network Advisor IP User Manual 1169
53-1002947-01
Configuration rules
38
Viewing a predefined configuration block
A configuration block is a continuous group of lines within a configuration file within which
conditions will be checked. The block is defined by the line that starts the block and the line that
ends the block.
1. Select Monitor > Policy Monitor.
The Policy Monitor dialog box displays.
2. Click Add.
The Add Monitor dialog box displays.
3. Click the Switch/Router Checks tab.
4. Select Add > Configuration Rule.
The Add Configuration Rule dialog box displays.
RFS Radio Interface check Checks whether the specified profile
is configured with Radio interfaces.
This condition should be used inside
the profile block. If the profile name is
not specified in the configuration or if
the user selects all the profiles
(profile.*), then it will match against
the first available profile. Yes Matches interface radio.* No
RFS Gigabit Ethernet Interface check Checks whether the specified profile
is configured with Gigabit Ethernet
interfaces. This condition should be
used inside the profile block. If the
profile name is not specified in the
configuration or if the user selects all
the profiles (profile.*), then it will
match against the first available
profile. Yes Matches interface ge.* No
RFS Fast Ethernet Interface check Checks whether the specified profile
is configured with Fast Ethernet
interfaces. This condition should be
used inside the profile block. If the
profile name is not specified in the
configuration or if the user selects all
the profiles (profile.*), then it will
match against the first available
profile. Yes Matches interface fe.* No
RFS AAA policy Health Check Interval Checks whether the health check
interval has been configured in the
AAA policy. No Matches health-check interval No
TABLE 109 Predefined conditions (Continued)
Name Description Use
regular
expression Matches/
Not Matches Configuration Lines in
exact
order